Speed Dial:
The Speed Dial allows you to control the cutting speed for an optimal cut on a variety
of materials. If you regularly cut on heavyweight materials, you may want to turn the
dial up to increase the cutting speed. For lightweight materials or for smaller, more
detailed cuts, you may want to turn the dial down to decrease the cutting speed.
After each adjustment, we recommend that you test the setting with a scrap piece of
material, readjusting as necessary until you achieve the desired results.
The display will indicate the speed level, ranging from one bar (“Min”) to ve bars
(“Max”). As a general rule, decrease the cutting speed if your cuts are being torn. If
this doesn’t work, change the blade or adjust the pressure.
Pressure Dial:
The Pressure Dial allows you to control how hard the cutting mechanism presses
against the material. For heavyweight materials, you may want to move the dial up
to increase the cut pressure. For lightweight materials, you may want to turn the dial
down to decrease the pressure. After each adjustment, we recommend that you test
the setting with a scrap piece of material, readjusting as necessary until you achieve
the desired results.
The display will indicate the pressure level, ranging from one bar (“Min”) to ve bars
(“Max”). As a general rule, increase the pressure if your selections are not being cut
completely through the material.
Basic Care
Blade Life
You can expect anywhere from 500 to 1500 single cuts from your cutting blade before
it requires replacement. Your actual cutting blade life will vary, depending on the set-
tings you use and the materials you cut. When the quality of your cuts decreases, it is
probably time to replace your cutting blade. For best results, use only genuine Cricut
Cake™ Replacement Cutting Blades, available at participating Cricut retailers.
Replacing the Cutting Blade
WARNING! Always unplug your Cricut Cake™ machine before replacing the
cutting blade.
To change the cutting blade, you must rst remove the cutting blade assembly. Refer
to page 20 in this manual for instructions.
After removing the cutting blade assembly, gently pull the blade away from the mag-
net holding it in place (Figure 1).
To install the new blade, carefully insert the shaft of the blade into the hole in the bot-
tom of the cutting blade assembly. The blade should be “sucked” up inside the shaft
if properly installed (Figure 2). The replacement cutting blade is now installed. Reinstall
the cutting blade assembly into the Cricut Cake machine by reversing the procedure
to remove the cutting blade assembly.
Figure 1 Figure 2
20 ENGLISH
ENGLISH 21
(5 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern