18 ENGLISH
TIP: After making your cutting selection, press the OK button to see the calculated
number of cuts that will t on the page.
TIP: After making your cutting selection, press the OK button to see the calculated
height of the cut.
TIP: The Auto Fill mode will only allow up to 300 duplicates of the selected character(s).
If you would like to cut more than 300, you can select two (or more) of the same
character(s) and then press the Auto Fill button. This would increase the duplicates to
600 (or more).
TIP: Certain modes can be combined, such as Portrait, Mix ’n Match, and Quantity.
However, the size modes (Fit to Page, Fit to Length, and Auto Fill) cannot be combined.
For example, if you select Fit to Page and then select Auto Fill, the Cricut Cake will
automatically deselect Fit to Page and select Auto Fill.
Functions on the Cricut Cake™ machine
The Auto Fill mode lls the page with as many
of the characters selected on the display as will
t on the page at the size selected. To use the
Auto Fill mode, press the Auto Fill button so that
the button is backlit in green. Then make your
character(s) selection, set the Size Dial, and
press CUT.
The Multi Cut function allows you to cut the cut
lines of a selected character(s) two, three, or
four times on top of the original cut lines. This
allows the machine to cut thicker materials. To
use the Multi Cut function, you must rst deter-
mine the number of multi cuts in the Settings
screen. Press the Settings button and advance
through the settings options until you reach the
Multi Cut menu. Use the plus and minus arrows
to select 2, 3, or 4 and then press OK to select.
Exit the Settings screen and then press the Multi
Cut button until it is backlit in green. Then make
your character selection(s), press CUT, and the
machine will use your Multi Cut setting to cut
the character(s).
The Center Point function cuts a character(s)
centered on a designated point. It is only avail-
able in the Landscape mode. To use the Center
Point function, move the cutting blade using the
Blade Navigation Buttons until the blade is over
the center of the cut. Press the Center Point button
until it is backlit in green. Then make your charac-
ter selection(s), press CUT, and the machine will cut
the character with the blade position you set as
the center of the cut.
(5 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern